AquaVape³ Water Filter incl. Easy Flow Glass Adapter for Mighty(+)/Crafty(+)
AquaVape³ Set for Mighty/Mighty+/Crafty/Crafty+ Vaporizer with 14" cut adapter made of pyrex glass
This AquaVape³ set comprises of our water filter AquaVape and an adapter with 14" cut which was specially developed for the Crafty+ and the Mighty+ models. This is an affordable option to upgrade your Crafty/Crafty+ or Mighty/Mighty+.
Water filter AquaVape³
Enjoy the pleasure of herbs in a cleaner and purer way when vaporizing! With the water filter the vapor of particles which can pass through the air holes and sieves into the mouth is cleaned. In addition to this the vapor is moistened providing for a greater tolerability for the bronchial tubes. The AquaVape Water Filter is made of robust borosilicate glass.
AquaVape³ Water Filter Adapter
With the water filter adapter, every water filter and every 14 mm glass bong can be operated on the original Crafty/Crafty+ or Mighty/Mighty+.
Improvements of the AquaVape³ compared to the AquaVape²:
-
Two-piece with cap: easy filling and easier cleaning
-
High quality and thick borosilicate glass
-
Smaller, slimmer and better to handle
-
Optimal amount of water is held and the perk slots are completely covered
-
Nevertheless, no high splash of water ... the mouth stays dry
-
Accurate 14 mm cut (no wobbling)
Details:
-
Height: 125 mm
-
Diameter: 30 mm
-
water filtration
-
a lot of percolators
-
Borosilicate glass / glassware
-
14er inside cut (14.5 mm)
IMPORTANT NOTES:
Turn the adapter carefully only until a tension is generated and the adapter is firmly seated on the Crafty/Crafty+/Mighty/Mighty+. Overtightening the adapter with too much force can damage your device.
Vaporizers are mostly electronic. Therefore they must not come into contact with water. Please do not fill too much water into the Aquavape and do not hold the bubbler too slanted to prevent water from leaking! Before putting the vaporizer on the vaporizer, please check that the cut is dry and that no water can run into the vaporizer or heating chamber!
Turn the adapter carefully only until a tension is generated and the adapter is firmly seated on the Crafty/Crafty+/Mighty/Mighty+. Overtightening the adapter with too much force can damage your device.
Vaporizers are mostly electronic. Therefore they must not come into contact with water. Please do not fill too much water into the Aquavape and do not hold the bubbler too slanted to prevent water from leaking! Before putting the vaporizer on the vaporizer, please check that the cut is dry and that no water can run into the vaporizer or heating chamber!
Scope of Delivery:
-
1x Laboratory glassware adapter with 14er cut for Mighty/Mighty+/Crafty/Crafty+
-
1x AquaVape³ water filter with 14er cut
